Rear Entry (Industrial Spec)
The cordura fabric is the heaviest and strongest of the fabrics in the Azdry material range.
This industrial spec suit is also available in nylon which is equally as strong but lighter and easier to clean. Both of these fabrics are available in various colours (see colour choice).
The industrial spec suit comes with steel toe cap and mid-sole heavy
duty boots, HD knee pads made from hypalon type material, reinforced seat pad and folded pocket as standard.
Specification may be altered to customers requirements plus many extras such as convenience zipper, reflective tapes etc.
Latex seals are fitted as standard, these seals are fitted onto the suit and are taped inside and outside. Heavy duty cuff seals are used which comes in four sizes plus sizing rings for the perfect fit.
Bellowed latex neck seal is used which are taped inside and out and come in four different sizes.
This pocket is usually made in the same fabric that the suit is made in and is incorporated in the side seam and top of the knee pad.
The pocket is approximately 18 cm wide, 29 cm long with an opening of 6 cm in depth at the top of the pocket and this is closed with a Velcro flap. Dimensions of the pocket may be altered for customers requirement at an extra cost.
The reinforced seat pad is an extra layer of material which is sewn into existing seams, the material is usually the same material that the suit has been made from.
Our HD knee pads are made from hypalon type material which is scuff resistant and extremely strong.
These are sewn in with the seams of the leg therefore no adhesive is used, so legs flexibility is not restricted.
If required this knee pad may be made longer and wider to suit customers requirements at an extra cost.
These boots are manufactured from PU and have excellent resistance against oils, fats etc and the durability to last up to three times longer than regular boots.
Much lighter in weight than rubber and PVC boots and have insulation for use down to minus 20° Celsius and meets all specification requirements for this type of industrial boot.